For Toyota/For Lexus ECU Flasher Read And Write ECU TCU via OBD For NEC 7F00XX Series MCU Chip Tuning Tool

Notice:

External 12V power for programmer powering in OBD mode!!!

USB powering ONLY !!!

Descpiption: ​ ​

For Toyota Flasher, a joint project by Autokey and P.C.M.flash, is a multipurpose programmer for Denso and Fujitsu Ten ECUs with NEC processors installed For TOYOTA/LEXUS/SCION vehicles with petrol and diesel engines through JTAG interface. OBD writing via CAN bus is supported. It is a unique solution in the chip tuning world. It covers almost all the models beginning from 2003-2004. It can read, flash, clear, verificate internal flash memory of microcontrollers if connected to the appropriate connector on the ECU circuit board.

​ ​

Advantages:

​

·Its own hardware interface allows to avoid all compatibility and driver problems;

​

·Work through built-in 20 or 26 pin JTAG connector;

​

·Full access to the ECU memory at high speed of more than 100 KB/s;

​

·Saving files in the open format;

​

·Firmware checksum verification and recalculation.

​

·SUPPORT 2015 + OBD WRITE and SOME MODELS 2015 + OBD READ

​

·can READ and WRITE via internal 20 pin or 26 pin connector. connection diagram for all known

​ ​

Supported ECUs:

​

For TOYOTA DENSO ENGINE CONTROL MODULE based on NEC 7F00XX series MCU:

​

76F0038

7F0038A

76F0039​

76F0039A

76F0040

76F0040A

76F0070 BGA

76F0085 BGA

saving in normal mode without any master-slave.

master only.

​

auto CHECKSUM CORRECTION support

​

These processors were introduced at the beginning of CAN support and as a rule with coachwork change.

Package List:

1pc* ECU Flash main unit

1pc* 12V/3A power out

1pc* 16pin cable for ecu reading by OBD

1pc* cable for BDM function

1pc* adapter for Mitsubshi reading by boot

1pc* USB cable to connect the tool to the computer

1pc* adapter

1pcs* pins

1pc* suitcase

Software Display:

Contact Information:

Email: buyobd@gmail.com
Tel: 86 15827411186
Whatsapp: 86 15827411186
Skype: Marshall.obd2